HP Latex 210 Printer User Manual
Page 50
20.
Use the wind-direction switch on the take-up reel motor to select the winding direction. Setting 1
winds the substrate so that the printed image faces in. Setting 2 winds the substrate so that the
printed image faces out.
The front panel shows you the correct setting based on the winding-direction decision you made
earlier.
21.
Press the
OK
button on the front panel. The Take-up reel has been successfully installed
message appears.
22.
The following image shows how the printer looks when it is operating. As substrate is fed from the
printer, it drops down in a loop and then up into the take-up reel spindle.
NOTE:
While the take-up reel is operating, make sure that the take-up reel sensors are not blocked.
NOTE:
The cutter is disabled when the take-up reel is in use.
46
Chapter 4 Handle the substrate
ENWW
Handle the substrate