HP Latex 210 Printer - Manual (Page 57)

9. Select the type of substrate you are loading.
NOTE: You should select the name of the particular substrate that you are using in your RIP
software, not in the front panel.
TIP: When loading very thin substrates, always select the substrate type as Banner to minimize
the vacuum pressure applied while loading; when loading very thick substrates, always select the
substrate type as HP Photorealistic to maximize the vacuum pressure. After loading and before
printing, go to the front panel and change to the correct type for the substrate you are loading:
select the icon, then select View loaded substrate > Change loaded substrate.
10. After passing through the printer, the loading accessory can be removed by hand.
11. The printer checks the substrate in various ways and may ask you to correct problems with skew or
tension.
NOTE: You can specify the maximum permitted amount of skew at the front panel: select the
icon, then select Substrate handling options > Max skew setting.
12. If you are loading transparent substrate without opaque borders, you are asked to enter the width
of the substrate and the distance of the right edge from the printer's side plate (as indicated by the
ruler on the front of the curing module).
13. If you have chosen double-sided printing, the front panel may ask a question about it at this point.
14. The printer calibrates the substrate advance.
ENWW The loading accessory 53
Handle the substrate