HP Latex 210 Printer - Manual (Page 75)

Substrates suitable for color calibration include even-surfaced adhesive vinyls (neither punched nor
perforated), PVC banners and some opaque, stiff textiles.
Some textiles require the take-up reel for successful printing. However, the take-up reel may fail to cope
with the backward movement of the substrate between the printing and scanning phases of color
calibration. To avoid this problem, proceed as follows.
1. Ensure that the take-up reel is enabled.
2. Advance the substrate until the loop-shaper reaches its lowest position.
3. Manually rewind the take-up reel, using the buttons on the take-up reel motor, to collect the
substrate and raise the loop-shaper until it almost touches the take-up reel spindle.
4. Set the take-up reel's wind direction to neutral.
5. Launch color calibration from the RIP.
6. When the color calibration has finished, you can re-enable the take-up reel.
Color profiles
Color calibration provides consistent colors, but consistent colors are not necessarily accurate. For
instance, if your printer prints all colors as black, its colors may be consistent but they are not accurate.
In order to print accurate colors, it is necessary to convert the color values in your files to the color
values that will produce the correct colors from your printer, your inks and your substrate. A color
profile is a description of a printer, ink and substrate combination that contains all the information
needed for these color conversions.
These color conversions are performed by your Raster Image Processor (RIP), not by the printer. For
further information on the use of color profiles, see the documentation for your application software and
for your RIP.
In addition to the color profiles used for printing, you may wish to calibrate and profile your monitor
(display device), so that the colors you see on the screen relate more closely to those that you see on
your prints.
Color reproduction tricks
Latex inks are a new technology, and there are some important guidelines when doing color
separations (such as when creating or modifying a new media preset within your RIP) that will help to
optimize the printer output in terms of color gamut, ink usage and print quality. These are as follows:
● To achieve the best dark colors in vinyl gloss and other substrates, use as much black and as little
composite (CMY) as possible when creating the ICC profile.
● Light inks should be avoided as much as possible in high-density colors such as secondaries and
tertiaries (dark red, blue, green, ...).
● Light inks should be restricted to the lowest-density colors, starting the use of dark inks as early as
possible. Typically, a color of more than 50% density should not contain any light inks.
● Light inks should be used at no more than 50% of maximum quantity. An excessive amount of light
inks can create gloss artifacts in vinyl gloss substrates.
Please refer to your RIP documentation for details of how to create or modify media presets.
ENWW Color profiles 71
Substrate settings