HP Color LaserJet 4650 Printer series - Manual (Page 66)

To set the color/black mix
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight COLOR/BLACK MIX.
7. Press to select COLOR/BLACK MIX.
8. Press or to select the desired option.
9. Press to select the option.
10. Press M
ENU
.
Tray behavior options
Tray behavior allows three user-defined options:
● USE REQUESTED TRAY. Selecting EXCLUSIVELY ensures that the printer will not
automatically select another tray when you indicate that a specific tray should be used.
Selecting FIRST allows the printer to pull from a second tray if the specified tray is
empty or does not match the settings specified for the print job. EXCLUSIVELY is the
default setting.
● Manually Feed. If you select ALWAYS (the default value), the system always displays a
prompt before pulling from Tray 1 (multipurpose tray). If you select UNLESS LOADED,
the system will only display the prompt if Tray 1 (multipurpose tray) is empty.
● PS DEFER MEDIA. This setting affects how non-HP PostScript drivers will behave with
the device. There is no need to change this setting if using the drivers supplied by HP. If
set to ENABLED, non-HP PostScript drivers will use the HP tray selection method as
the HP drivers do. If set to Disabled, some non-HP PostScript drivers will use the
PostScript tray selection method instead of the HP method.
To set the printer to use requested tray
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight TRAY BEHAVIOR.
7. Press to select TRAY BEHAVIOR.
8. Press to select USE REQUESTED TRAY.
9. Press or to select EXCLUSIVELY or FIRST.
10. Press to set the behavior.
11. Press M
ENU
.
52 Chapter 2 Control panel ENWW