HP LaserJet M2727 Multifunction Printer series - Manual (Page 131)

If the fax number you are calling has been assigned to a one-touch key, press that key.
-or-
If the fax number you are calling has a speed dial or group-dial entry, press Phone Book , use the
alphanumeric buttons to specify the speed dial or group-dial entry, and then press OK .
6. On the control panel, press Start Fax .
The control-panel display shows the following message: Send from glass? 1=Yes 2=No.
7. Press 1 to select Yes. The control-panel display shows the following message: Load page: X
Press OK , where X is the page number.
8. Press OK . After scanning the page, the product control-panel display shows the following message:
Another page? 1=Yes 2=No.
9. If you have more pages to scan, press 1 to select Yes, and then repeat step 3 for each page of the
fax job.
-or-
If you are finished, press 2 to select No, and then go to the next step.
Fax from the automatic document feeder (ADF)
NOTE: The ADF capacity is up to 50 sheets of 80 g/m 2 or 20 lb media.
CAUTION: To prevent damage to the product, do not use an original that contains correction tape,
correction fluid, paper clips, or staples. Also, do not load photographs, small originals, or fragile originals
into the ADF. Use the flatbed glass to scan these items.
1. Insert the top-end of the stack of originals into the ADF input tray, with the media stack face-up
and the first page to be copied on top of the stack.
If the media is longer than Letter- or A4-sized paper, pull out the ADF input tray extension to support
the media.
2. Slide the stack into the ADF until it does not move any farther.
Document loaded appears on the control-panel display.
ENWW Use fax 119