Ip address, Manual configuration, Automatic configuration – HP LaserJet M2727 Multifunction Printer series User Manual
Page 54: Ipv4 and ipv6 settings, Link speed setting, Ip address link speed setting
NOTE:
Changing the network configuration might require you to change the browser URL before you
can communicate with the product again. The product will be unavailable for a few seconds while the
network resets.
IP address
The product IP address can be set manually, or it can be configured automatically via DHCP, BootP, or
AutoIP.
Manual configuration
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Network config, and then press
OK
.
3.
Use the arrow buttons to select TCP/IP config, and then press
OK
.
4.
Use the arrow buttons to select Manual, and then press
OK
.
5.
Use the alphanumeric buttons to type the IP address, and then press
OK
.
6.
If the IP address is incorrect, use the arrow buttons to select No, and then press
OK
. Repeat step
5 with the correct IP address, and then repeat step 5 for the subnet mask and default gateway
settings.
Automatic configuration
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Network config, and then press
OK
.
3.
Use the arrow buttons to select TCP/IP config, and then press
OK
.
4.
Use the arrow buttons to select Automatic, and then press
OK
.
It may take several minutes before the automatic IP address is ready for use.
NOTE:
If you want to disable or enable specific automatic IP modes (such as BOOTP, DHCP, or
AutoIP), these settings can be changed by using the embedded Web server or HP ToolboxFX only.
IPv4 and IPv6 settings
Only the IPv4 protocol can be configured manually. The IPv4 protocol can be set from HP ToolboxFX
or from the product control panel. The IPv6 protocol can be selected only from the product control panel.
Link speed setting
NOTE:
Incorrect changes to the link speed setting might prevent the product from communicating with
other network devices. For most situations, the product should be left in automatic mode. Changes can
cause the product to power cycle. Changes should be made only while the product is idle.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Network config, and then press
OK
.
3.
Use the arrow buttons to select Link speed, and then press
OK
.
42
Chapter 5 Connectivity
ENWW