GE ZV925SLSS - Manual (Page 13)

13
Installation Instructions
STEP 3 CUT DUCT TO LENGTH FOR
VENTED INSTALLATION
• Measure from
house duct to
exhaust opening.
• Cut the 8" duct
length to size.
• Slip duct over the
exhaust opening.
• Seal the connection
with duct tape.
Duct
House
duct
Frame
height
Duct
length
STEP 4 INSTALL THE SUPPORT FRAME
• Raise the support toward
the ceiling.
• Thread the house wiring
through one of the large
holes, preferably on the
left side.
• Carefully engage the
ceiling mounting screws
to the keyhole slots AND
the house duct in the top
of the frame.
• Tighten the 4 mounting
screws against the frame.
• Install 2 safety screws.
• Use duct tape to seal the
duct connection at the top.
Duct
STEP 5 INSTALL HOOD ATTACHMENT
SCREWS
• Install 4 hood attachment screws in the bottom of
the support as shown. Leave 1/4" gap between
screw head and support flange.
Safety
screws
Keyhole
slots
House
wiring
Keyhole
slots
Install 4
attachment
screws
,167$//$7,21³9(17('727+(2876,'(