GE ZV925SLSS - Manual (Page 18)

18
Installation Instructions
• Align the template with the marks on the ceiling
and tape in place.
– Be sure the template is oriented correctly
with the front of the hood.
• Use a plumb bob to be sure the mounting holes
will provide parallel alignment with the countertop
below.
• Center punch all hole locations.
• Drill pilot holes in the 4 screw locations. Use a 3/16"
bit and drill approximately 1-1/2" deep.
• Drive 4 hex head wood screws into the center of
the ceiling joists and cross framing. Leave a 1/4"
gap to allow the screw head to engage the keyhole
slots on the support frames.
STEP 1 MOUNT TEMPLATE
STEP 2 ADJUST FRAME HEIGHT
•Measure exact ceiling height.
• Find the exact frame height
required on the chart on page 6.
• Place the support on a work
surface. Remove 2 screws on
each of the 4 sides of the frame
to loosen the upper structure,
lower structure and blower/
motor.
• Adjust the height “X”, according
to the chart on page 6.
• Use a marker pen to indicate
where screw holes should align
in the assembled upper, lower
and blower/motor pieces.
1/4" Gap
24"min.
30"max.
36"min.
Frame
height
2-3/4"
Ceiling
height
X
49-80406 Printed in Italy 04-06 JR
36≤ Hood
Template
8-1/2
≤Dia.
Cut a 1≤ Dia. Wire Access Hole
Cut a 1≤ Dia. Wire Access Hole
Drill 3/16≤
Pilot Holes
Approx. 1-1/2≤ Deep
Drill 3/16≤
Pilot Holes Approx. 1-1/2≤
Deep
10-1/16≤ to
Centerline of Holes
7-1/16≤ to
Centerline
of Holes
FRONT OF HOOD
7-1/16≤ to
Centerline of Holes
,167$//$7,21³5(&,5&8/$7,1*
NOTE: Do not cut the
duct opening shown
on the template for
this recirculating
installation.
NOTE: Low ceilings may require that
the lower portion of the support frame be
removed. The upper support frame may be
secured directly to the blower/motor. Refer
to the chart on page 6 for your ceiling
height and to be sure the duct cover trim
piece will fit.
Mark
each
piece to
indicate
where
screw
holes
align.