Ag Leader InSight Cotton Harvest Insert Ver.6.0 Users Manual - Manual (Page 11)

InSight™ Firmware Version 6.0
583
PN: 2002881 Rev.F
C
ONFIGURATION
S
ETTINGS
To access the Configuration Settings window, first highlight a configuration in the list and then press the
Configuration Settings button.
Configuration Settings window
Setting Description
The Header Offset shows the distance between the
centerline of the vehicle and the center of the header’s
swath. To change these settings, use the numeric keypad to
enter this distance, then use the drop-down menu to enter
the direction.
The Ground Speed Sensor area shows the primary and
secondary ground speed source.
The Active Rows area shows which rows are equipped with
sensors. If you wish to change these settings, press the
checkboxes that correspond to the number of sensors in your
configuration. In the example at left, the operator has
selected four sensors on four rows.
In order to log data on the Run screen, you must
specify the correct sensor configuration. Otherwise, when
you attempt to set up an operating configuration at the
Run screen’s Field Operation Wizard, you will see an error
message stating that “The cotton flow sensor
configuration does not match the active picker.”