Standard create vehicle procedure, Standard create vehicle – Ag Leader ParaDyme Operation Guide User Manual
Page 16

14
Ag Leader Integra and Versa Firmware Version 4.3 / Edge Firmware Version 5.1
1. Press the Setup Wizard button. the GPS Setup
screen appears.
2. Press the Change Primary button. The Enter PRN
screen appears.
Note:
PRNs are satellite identifiers. Enter the primary satellite PRN to use for WAAS correction. For
the US WAAS, try PRN 133 first, then PRN 138. If the signal is weak, consult the FAA web site, or
contact your dealer for updates.
3. Use the keypad to type a PRN number and press
the check mark button.
4. Depending on the optional radio hardware installed
on your system, the wizard guides you through the
necessary configuration steps. When finished, the
Precision Settings Info screen appears.
5. Press the Change Mode button. The Available
Precision Settings screen appears.
6. Select a precision setting and press the check mark
button to automatically move on to the Standard Create
Vehicle Procedure. There are five precision settings
available:
• RTK Only
• Flex High Accuracy (0 - 4 inches)
• Flex Low Accuracy (0 - 12 inches)
• OmniSTAR Only
• WAAS Only
Note:
See the Precision Settings section of
“Using the GPS Menu” on page 37
for details about
precision settings.
Standard Create Vehicle Procedure
Once the initial vehicle has been setup, pressing the Setup Wizard button brings you directly to the
standard vehicle setup screens.