Innovate Motorsports OT-2 - Manual (Page 13)

OBD-II Protocol: Select which OBD-II protocol to connect with. We suggest
leaving this setting set at Automatic.
Channel Functions: The channels that are listed are the channels that the
ECU reports as available. You will notice that you have the option of selecting
whether you want the channel to be Normal or Low priority. This feature will
allow you to scan non essential channels less often to gain greater speed for
more important channels. See chapter 6 on OBD-II Channel speed for more
information,
3. Press Done on the upper right hand corner when done configuring.
4 LogWorks and LM Programmer (Windows PC)
The LogWorks application is used to read and analyze previously logged data or you can stream
data from the OT-2 real-time. With the LogWorks software you may chose to either connect via a
wireless network or the USB cable.
LM Programmer is used to configure and select the OBD-II channels, read and clear DTC codes,
and update the firmware. The LM Programmer software allows you to chose to either connect via
a wireless network or the USB cable, but a USB connection is required to update the firmware.
4.1 Establishing a connection to LogWorks
Depending on your network and personal firewall settings, you might receive a warning
about network access being blocked when you first run either LogWorks or LM
Programmer. It is very important that you select “Unblock”, otherwise the applications will
not be able to access the hardware wirelessly!
1. Connect the OT-2 to the USB port on your computer or establish a WiFi connection.
2. Run LogWorks (version 3.04 or newer)
LogWorks can be found under “All Programs”, “LogWorks3”. After a few moments a screen like
this should appear: