Innovate Motorsports OT-2 - Manual (Page 7)

To connect, select the network by clicking on it so it is highlighted (as shown above), and then
pressing the “Connect” button in the bottom right corner of the screen. Since the Ad Hoc network
that the OT-2 creates is unsecured, you may get a warning like this:
Select “Connect Anyway”. After Windows reports that you have joined the network, there is a
brief period of 1-5 seconds while the computer is still obtaining some additional information from
the OT-2 (just like joining any other network). After that, you are good to proceed.
2.4.3 USB Connection
1. Connect one end of the USB cable to the OT-2 and the other end to your computer.
2. Windows will now recognize the device and prompt the “New Hardware Wizard.” Click
Next.
3. Select “Install the Device Automatically” and click Next.
4. A progress screen might appear. During this installation process the screen below will
pop up. Click “Continue Anyway.”
5. The last screen will inform you that the unit has been successfully installed. Click “Finish.”
The unit is installed and ready to use.