Asante Technologies 5324 - Manual (Page 24)

Factory Defaults
Page 1-9
Factory
Defaults
The IntraSwitch 5324 is shipped with the following
configuration default settings:
Table 1-2 Factory Default Configurations
▲
Important: When the switch is reset (pow-
ered off and then on), all settings are returned to
the factory defaults listed above
except for the
IP Address, Subnet Mask, and Default Gateway;
these items revert to the first addresses assigned
to them.
Configuration Default Setting
IP address 0.0.0.0
Important: The first IP address that is
assigned to the IntraSwitch becomes the new
factory default setting.
Subnet Mask 0.0.0.0
Important: The first subnet mask that is
assigned to the IntraSwitch becomes the new
factory default setting.
Default Gateway 0.0.0.0
Important: The first default gateway address
that is assigned to the IntraSwitch becomes
the new factory default setting.
Switching Mode Store-and-forward
10Base-T Ports Half Duplex
10/100TX Port and
MII Expansion Ports
Auto-Negotiation
Spanning Tree Enabled on ALL ports