Asante Technologies 5324 - Manual (Page 79)

Configure Spanning Tree Parameters
Page 5-31
3 Select the port number you want to enable
or disable Spanning Tree on by typing
l on
the Port Parameter Menu and entering the
port number at the prompt.
∆
Note: The 10/100TX port is port number
25, the MII ports (MII I and MII 2) are port
numbers 26 and 27, respectively.
4 Press return.
5 Type e to enable Spanning Tree on the port;
type d to disable Spanning Tree on the port.
6 Type q to exit this menu and return to the
Spanning Tree Parameter Menu.
7 Type a to apply the changes.
▲
Important: The change will not take
effect until
Apply is selected from the Span-
ning Tree Parameter Menu.