Asante Technologies 5324 - Manual (Page 55)

Logging into the Configuration Menu
Page 5-7
Table 5-2 Configuration Menu Items
Menu Item Description
Config System
Administration Information
Displays and allows you to change the name,
location, and contact information for the
IntraSwitch.
See “Configure System Administration
Information” on page 5-9.
Config TCP/IP Parameters Displays and allows you to change the
information needed to access the IntraSwitch
over the network (in-band management).
See “Configure TCP/IP Parameters” on page
5-11.
Config Bootstrap
Parameters
Displays and allows you to change the
parameters used for downloading a new
version of software for the IntraSwitch.
See “Configure BootStrap Parameters” on
page 5-13.
Config SNMP Parameters Displays and allows you to change the
IntraSwitch’s SNMP (Simple Network
Management Protocol) parameters; such as,
read/write settings, trap authentication, and
trap receivers.
See “Configure SNMP Parameters” on page
5-16.
Config Port Parameters
Allows you to manually configure each of the
switch’s ports for speed, connection, link mode,
and auto-negotiation.
See “Configure Port Parameters” on page 5-20.
Config RMON Parameters Displays and allows you to change the switch’s
RMON parameters.
See “Configure RMON Parameters” on page
5-24.
Config MAC Forwarding
Table Parameters
Displays and allows you to change the entries
in the IntraSwitch’s MAC Forwarding Table.
See “Configure MAC Forwarding Table
Parameters” on page 5-25.
Config Spanning Tree
Parameters
Displays the switch’s Spanning Tree
parameters and allows you to enable or
disable Spanning Tree.
See “Configure Spanning Tree Parameters” on
page 5-28.