Asante Technologies 5324 - Manual (Page 82)

Console Management
Page 5-34
Reset EEPROM to Default
This option resets the IntraSwitch’s values to the factory
default.
▲
Important: This procedure reverts all informa-
tion to the factory default settings
except for
the switch’s IP address, subnet mask, and
default gateway.
See “Factory Defaults” on page 1-9 for a list of all
the switch’s factory default settings.
To reset the EEProm:
1 Type e from the Configuration Menu.
The following command line appears at the bot-
tom of the Configuration Menu:
Figure 5-13 Reset EEProm to Default command line
2 Type y to reset the EEPROM to default or N to
cancel the reset.
3 Reset the IntraSwitch by turning the switch off,
and then on again.