Vaisala HMP228 - Manual (Page 69)

HMP228 Transmitters
M210282en-A Appendix 1: Serial commands
63
XPRES Setting the pressure for mixing ratio calculations tempo-
rarily
XPRES pppp.pp <cr>
pppp.pp = pressure (hPa)
The function and format of XPRES are the same as those of the PRES com-
mand except that with XPRES command the setting is valid only until a reset
is given, power is turned off or pressure is set to zero with XPRES. After this
the pressure stored with command PRES is valid again.
CDATE Entering calibration date
CDATE xxxxxx <cr>
xxxxxx = calibration date (000101...991231)
When the latest calibration date has to kept in memory, it is entered as fol-
lows:
>CDATE 940506 <cr>
If the command is given without the date, the transmitter outputs the latest
calibration already in memory.
>CDATE <cr>
940420
The date can be given in any format; however, the maximum number of digits
is six.
DATE Setting the date
DATE <cr>
For example, to enter a new date:
>DATE <cr>
Current date is 1993-01-30
Enter new date (yyyy-mm-dd) : 1993-06-12 <cr>
When the current date is asked, the new date is passed with <cr>.