Vaisala HMP228 User Manual

Page 74

Advertising

HMP228
Appendix 2: Display commands

M210282en-A

Selecting parity:

Selecting data bits:

Selecting stop bits:

Full duplex/half duplex:

The processor does not allow the following combinations:

•

no parity, 7 data bits, 1 stop bit: if this combination is given the
HMP228 programme will change the number of stop bits to 2

•

even or odd parity, 8 data bits, 2 stop bits: if this combination is given
the programme changes the number of stop bits to 1

NOTE

The serial bus settings become effective only after reset.

1.1.1.3

Setting the transmitter address

Address is used when more than one transmitter is connected to one serial bus;
it makes it possible to communicate with one transmitter at a time.

•

Select More in the main menu and Addr in the More menu; the
following is displayed:

Advertising