Vaisala HMP228 - Manual (Page 76)

HMP228
Appendix 2: Display commands
M210282en-A
70
1.1.2.1 Setting the serial interface operation mode
• Select Mode in the main menu; the following is displayed:
• Select Serial output:
• The currently valid setting flashes. Select the desired mode with the
arrow keys and press ENT. After this the programme returns to the
Mode Menu.
• When Run mode is selected, the currently valid output interval is dis-
played:
The output interval setting can be changed as follows:
• press CL
• the number starts flashing
• if the interval needs to be changed, press CL again and enter the new
interval; otherwise press ENT
• the unit (s, min, h) starts flashing
• the unit can be changed with the arrow keys and acknowledged with
ENT
• after this the programme returns to Mode menu