Red Lion PAX2C - Manual (Page 21)

21
The following programming steps are only available in the Advanced
Operating Mode.
These parameters allow Line n backlights to change color, or alternate
between two colors when the mapped parameter is activated. When multiple
backlight assignments are programmed for a particular zone, the color priority
is defined as follows (from Lowest to Highest): Grn, Org, Red, GnOr, RdOr, RdGn
BACKLIGHT ASSIGNMENT SELECTIONS
NONE = Backlight color change disabled
Out1 = Output 1
Out2 = Output 2
Out3 = Output 3
Out4 = Output 4
ALr = Alarm
MAN = Manual Control Mode
The following two programming steps are only available when the Backlight
Assignment is configured as an Alarm (Alr). These steps apply to each of the six
different backlight color assignment parameters.
ALARM LOGIC MODE
SNGL And Or
The PAX2C supports three different modes when an output is
assigned as an alarm:
SNGL = Any single alarm
And
= Allows multiple alarms to be mapped to an output
using AND Boolean logic. For example: If AL1 and
AL2 are active, the output will energize.
Or
= Allows multiple alarms to be mapped to an output
using OR Boolean logic. For example: If AL1 or
AL2 are active, the output will energize.
ALARM MASK ASSIGNMENT
NO YES
Selects the alarms to be logically combined per the Alarm Logic
Mode selection. Any alarms configured as YES will be used in the
Boolean logic calculation. If the Alarm Logic Mode is assigned as
Single (SNGL), the last alarm selected as YES will be used.
LINE n GREEN BACKLIGHT ASSIGNMENT
NONE Out1 Out2 Out3 Out4 ALr MAN
Select the parameter to be assigned to Line n Green Backlight.
LINE n ORANGE BACKLIGHT ASSIGNMENT
NONE Out1 Out2 Out3 Out4 ALr MAN
Select the parameter to be assigned to Line n Orange Backlight.
LINE n RED BACKLIGHT ASSIGNMENT
NONE Out1 Out2 Out3 Out4 ALr MAN
Select the parameter to be assigned to Line n Red Backlight.
LINE n GREEN-ORANGE BACKLIGHT ASSIGNMENT
NONE Out1 Out2 Out3 Out4 ALr MAN
Select the parameter to be assigned to Line n Green-Orange
Backlight.
LINE n RED-ORANGE BACKLIGHT ASSIGNMENT
NONE Out1 Out2 Out3 Out4 ALr MAN
Select the parameter to be assigned to Line n Red-Orange
Backlight.
LINE n RED-GREEN BACKLIGHT ASSIGNMENT
NONE Out1 Out2 Out3 Out4 ALr MAN
Select the parameter to be assigned to Line n Red-Green
Backlight.
LGIC
Lnn
SNGL
ASEL
Lnn
NO
An
Grn
Lnn
NONE
OrNG
Lnn
NONE
rEd
Lnn
NONE
GnOr
Lnn
NONE
rdOr
Lnn
NONE
rdGn
Lnn
NONE