High Country Tek PLD, Powerline / universal single / dual coil PWM Valve Driver - Manual (Page 19)

Part No:- 021-00155 RevD7 PowerLine System Controller User Guide Page | 19
PowerLine User Guide
Manual PWM%
Selection from Menu ->
Control Logic-> Manual PWM% Mode
This feature allows the user to manually
control the output current to coils ‘A’ and ‘B’
( PWM% ) by the using the ‘Virtual
Potentiometer’ shown colored as ‘Yellow’
on the screen to the left.
This option can be used for coil and system
setup and is ideal for troubleshooting.
NOTE for information:
The “Current = LOS Current” status message is always displayed ( not seen on this screen shot )
on the GUI when using or in this controller mode.
IMPORTANT NOTE – DUAL COIL OPERATION:
The output of either ‘A’ or ‘B’ output will go from the respective ‘I Min’ setting to ZERO (0mA ) when crossing
through command mid-point. The valve outputs do NOT jump from one I Min to the other.