MagTek MICRImage - Manual (Page 10)

MICRImage Check Reader
2
The following are operational commands that are image specific (see Section 4 for a complete
description of these commands):
• TG – TIFF tag command
• TI – Transmit Image command
• FM – File Memory command
• SI – Store Image command
• SF – Send next image File command
• TC – Set file and timer counter
command
• IS – Image Status command
• AI – Append Image command
• BC – Bar Code command
COMMAND LINE SYNTAX
Unless otherwise noted, commands are “free form” in that spaces may be inserted between
parameters, numbers, and file names (but not between digits). These spaces are ignored. Spaces
within a string are retained.
Lower case letters are converted to upper case letters except in strings. Strings must end with ‘]’
or <CR>. If ‘\’ is used in a string, the character that follows it replaces the ‘\’. For example, if
the command line has the string: Hello[World\] and \\us\\], the resulting string will be:
Hello [World] and \us\.
All commands must end with <CR>.
INSTA-CHANGE CHECKS
The Insta-Change check is a MICR encoded document that contains commands and options used
to set configuration parameters in the MICRImage Reader. Multiple commands and options may
be contained on one Insta-Change check. Also, multiple Insta-Change checks may be required to
configure some of the parameters.
When used, the Insta-Change checks are run through the MICR Reader the same as a standard
check, and the options to be used are automatically configured. When the Insta-Change check is
run through the MICR Reader and read successfully, the LED indicator will blink green. If the
LED indicator turns red, the read is not successful. Try again or use a different Insta-Change
check. To obtain Insta-Change checks, notify a MagTek representative and specify what option
will be used.
MICRBASE SETUP PROGRAM FOR WINDOWS
The MICRbase setup program (P/N 22000021) allows the user to control all the programmable
options available in the MICRImage Reader.