MagTek MICRImage - Manual (Page 40)

MICRImage Check Reader
32
The following optional parameters may be used in any order:
Cn Comm port as described in the TI command.
Fn Transfer protocol as described in the TI command.
A Send all remaining files. If the transfer protocol is
XMODEM or XMODEM-1K, only the next file is sent.
N name, …] Sends the named files. The names may be separated by a
comma or spaces. If a named file is not found, the command is aborted and
an error is returned. If the transfer protocol is XMODEM OR XMODEM-
1K, only the first named file is sent
Example: SF C0 F3 N myimage.tif yurimage.tif<CR>
TC – SET FILE TIMER/FILE COUNTER COMMAND
This command is used to set two internal counters in the MICRImage whose values may be inserted into
file names using the TI and SI commands. They both set to zero at power-on. The following optional
parameters may be used in any order:
Tn Sets the file timer to n seconds. This value is incremented each second. The
maximum value is 4,294,967,295 which rolls over to zero.
Cn Sets the file counter to n. The maximum value is 65,535 which rolls over to zero.
The current value is used when a new file name is created and is then incremented.
Example: TC T1000 C50<CR>
If this command is used without parameters, the current values are returned.
Example:
TC<CR> may return
TC=T1003,C50<CR>
IS – IMAGE STATUS COMMAND
This command instructs the MICRImage to transmit the status of the current image in local memory. To
execute, send the command as follows:
IS<CR>