Extended replies, No micr’ response, Swd command – auxiliary port parameters – MagTek MICRImage User Manual
Page 20: Table 2-6. swd command – auxiliary port parameters
MICRImage Check Reader
12
If Multiple Message:
<STX>‘M’[TK1]<ETX><STX>‘M’[TK2]<ETX><STX>‘M’[TK3]<ETX>
If Single Message:
<STX>‘M’[TK1] [TK2] [TK3]<ETX>
Extended Replies
There are a number of commands in the standard MICR command set that do not provide any
response when the operation is completed or with a simple '?<CR> when an error occurs. By
setting this option, commands that normally provide no response will return 'OK<CR>' if the
command executes successfully. For commands that respond with a '?<CR>' to report an error,
the extended reply is '?xxx<CR>' where xxx is a three-digit error code. See Appendix D for a
complete listing of the error codes.
‘No MICR’ Response
For applications where both MICR and non-MICR encoded documents will be scanned, setting
this option will provide a 'No MICR' response when no MICR characters are detected.
SWD COMMAND – AUXILIARY PORT PARAMETERS
The SWD command, shown in Table 2-6, controls the communication parameters for the RS-232
Auxiliary Port.
Table 2-6. SWD Command – Auxiliary Port Parameters
BITS FUNCTION
7
6
5
4
3
2
1
0
0
0
0
Baud Rate: 57600
0
0
1
Baud Rate: 38400
0
1
0
Baud Rate: 115200
0
1
1
Baud Rate: 1200
1
0
0
Baud Rate 2400
1
0
1
Baud Rate: 4800
1
1
0
Baud Rate: 9600
1
1
1
Baud Rate: 19200
0
0
0
Data, Stop Bits, Parity: 8, 1, None
1
0
0
Data, Stop Bits, Parity: 8, 2, None
0
0
1
Data, Stop Bits, Parity: 8, 1, Even
1
0
1
Data, Stop Bits, Parity: 8, 1, Odd
0
1
0
Data, Stop Bits, Parity: 7, 1, Even
1
1
0
Data, Stop Bits, Parity: 7, 2, Even
0
1
1
Data, Stop Bits, Parity: 7, 1, Odd
1
1
1
Data, Stop Bits, Parity: 7, 2, Odd
0
CTS/DSR: Use
1
CTS/DSR: Ignore
0
Intercharacter
Delay:
No
1
Intercharacter
Delay:
Yes