Campbell Scientific RTDAQ Software - Manual (Page 51)

Section 4. The RTDAQ Main Screen
dataloggers this setting can be selected when the program is sent to the
datalogger.
Run On Power-up sets the file to run when the datalogger is powered down
and powered back up.
A file set to Run Now and Run On Power-up will be shown as Run Always
in the File Control window.
Delete - Highlight a file and press the Delete button to remove the file from the
datalogger's memory. A running program may not be deleted.
Stop Program halts execution of the currently running datalogger program.
For all dataloggers but the CR800, CR1000, and CR3000, note that all data
tables will be deleted when the program is stopped. For a CR800, CR1000, or
CR3000 select the option to stop the program and retain the data files, or to
stop the program and erase all data files.
If a CR800, CR1000, or CR3000 program has been stopped, use the Run
Options to restart it. Once again, you will be able to choose whether to retain
or erase the data files. You can also choose a new program file to run.
4.6.3.4.4 Right-Click Menu Options
When a file name is selected, pressing the right mouse button displays a menu
with the Retrieve File, Delete File, Rename File, Run Options, and Stop
Program options.
4.6.3.5 Calibration Wizard
This item can be used to calibrate measurements being made by the currently
connected datalogger. The program in the datalogger must be written with the
proper instructions to enable these calibrations.
For complete information on how to activate and use the Calibration Wizard,
see Section 9 “Calibration and Zeroing”.
4-15