Campbell Scientific RTDAQ Software - Manual (Page 76)

Section 5. Program Creation and Editing
Background Color - Displays a color selection dialog to set the color of the
CRBasic program window.
Wrap Text When Printing - When this option is selected, long lines that
extend past the right margin will be wrapped to the next line. This option
affects printing, as well as the Print Preview mode. A check mark will appear
next to the option in the menu when it is selected.
Display Last Window Used - When this option is enabled, the program that
was active in the CRBasic Editor when it was last closed will be visible when
the Editor is reopened. If this option is disabled, no program will be loaded
when the Editor is opened. A check mark will appear next to the option in the
menu when it is selected.
Close Message Window – After you have pre-compiled your program with
the Compile | Compile menu item, or using the toolbar, a message window
opens up at the bottom of the CRBasic Editor main screen. This option will
close down that message window.
View Instruction Panel – Select this option to View or Hide the instruction
panel which displays a list of available instructions which can be used in your
datalogger program based on the pre-defined instruction filter selected with the
drop-down selection box.
5.1.3.9 CRBasic Editor Tools Menu
This menu item allows you to use special tools associated with the operation of
the editor.
5.1.3.9.1 Edit Instruction Categories
Edit Instruction Categories allows the user to create one or more custom list
of instructions. If a category of instructions is selected from the Instructions
Panel, the entire list of instructions in the Editor will be filtered to show only
those instructions in the selected category. (Note: The default categories
cannot be edited or deleted.)
To create a new list, first select the Add New Category button and provide a
name for the user-created category. Next, ensure the category name is selected
and click the Edit Category button to bring up the Select Instructions dialog
(shown below). Instructions that should be included in the new list are
indicated by a check in the box to the left of the instruction name. This feature
allows the user to display a filtered instruction list containing only those
instructions most often used. Press OK to save the list.
5-16