Wiring: spyglass display, Fig. 11, Fig. 12 – Wesley BCT-6200-6SA User Manual
Page 23
Curtis 1243
GEN
2 Manual,
Rev. B
15
2 — INSTALLATION & WIRING:
Spyglass Display
Fig. 11
Wiring for fault
outputs, when used to drive
LEDs. Alternatively, Pin 2
can be used for a pump me-
ter input, and Pin 3 can be
used to interface an external
enable circuit.
B-
+
-
Fault 1 output (Pin 2)
Fault 2 output (Pin 3)
WIRING: Spyglass Display
The Curtis 840 Spyglass features an 8-character LCD display that sequences
between hourmeter, BDI %, and fault messages. Depending on the model,
either three or six indicator LEDs are also located on the face of the gauge.
See Section 7 (Diagnostics and Troubleshooting) for more information on the
Spyglass displays.
The mating 8-pin connector is Molex 39-01-2085, with 39-00-0039
(18–24 AWG) pins.
Fig. 12
Wiring guide and
mounting dimensions for
Curtis Spyglass (6-LED
model shown; dimensions
and wiring are identical for
the 3-LED model).
SPYGLASS
1243
·GEN·2
CONTROLLER
PIN #
FUNCTION
PIN #
1–4
N.C.
–
5
+12V, +15V
4
6
receive data
3
7
N.C.
–
8
ground (B+)
2
58
(2.25)
44 (1.75)
8
58 (2.25)
52
(2.0)
“U” clamp for
up to 6 (0.25)
panel thickness
5
4
1
WIRING GUIDE
3
4
1
2
0
1
Dimensions in millimeters (and inches)