Wesley BCT-6200-6SA User Manual
Page 60
Advertising
Curtis 1243
GEN
2 Manual,
Rev. B
52
3 — PROGRAMMABLE PARAMETERS:
Fault Code Parameters
BDI LOCKOUT
When the BDI lockoutiparameter is programmed On, the Fault 2 output (at
Pin 3) can be used as an interface to an external auxiliary enable circuit. When
BDI%=0, the Fault 2 output will be high; when BDI%≥1, the Fault 2 output
will be low.
When BDI lockout is programmed Off, the Fault 2 output is determined
by the setting of the Fault Code parameter.
Advertising
This manual is related to the following products: