Allied Telesis x600-48Ts/XP - Manual (Page 63)

x600 Layer 3 Gigabit Ethernet Switch Installation Guide
63
Caution
Do not force AT-StackXG module into place. Doing so may damage
the connector pins on the backplane inside the chassis. If there is
resistance, remove the module and reinsert it after verifying that the
edges of the card are properly aligned in the guides in the chassis’
module slot.
Figure 29. Installing the AT-StackXG Stacking Module
4. Secure AT-StackXG module to the chassis by tightening the two
captive screws with a cross-head screwdriver.
Figure 30. Securing the AT-StackXG Stacking Module
1242
AT-LX44CPU
CVR
AT-Sta ckXG
Stack Po
rt 1
Stack Po
rt 2
1243
AT -LX44CPUCV
R
AT-StackXG
Stack Port 1
Stack Port 2