Allied Telesis x600-48Ts/XP - Manual (Page 74)

Chapter 4: Cabling the Network Ports
74
Powering on a Switch
To power on a switch, perform the following procedure:
1. Position the power cord retaining clip in the up position, as shown in
Figure 38.
Figure 38. Power Cord Retaining Clip in the Up Position
2. Plug the power cord into the AC power connector on the rear panel of
the unit (see Figure 39).
Figure 39. Connecting the AC Power Cord
3. Connect the other end of the power cord to an appropriate AC power
outlet. For power specifications for the switch, refer to “Power
Specifications” on page 88.
Warning: Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.
 E3
100-240V
AC ~
100-240V
AC ~