Allied Telesis AT-S80 - Manual (Page 133)

AT-S80 Management Software User’s Guide
Section I: Using the Menus Interface 133
Enabling and Disabling SNMP Traps
The procedures in this section describe how to enable, disable, and modify
traps. See the following procedures:
ˆ “Enabling an SNMP Trap” on page 133
ˆ “Deleting a Trap Receiver” on page 135
ˆ “Modifying a Trap Receiver” on page 135
Enabling an
SNMP Trap
To enable an SMNP trap, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 26 on page
124.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is shown in Figure 27 on page 125.
3. From the SNMP Configuration Menu, type T to select Trap Receiver
Configuration.