Allied Telesis AT-S80 - Manual (Page 46)

Chapter 3: Basic Switch Parameters
46 Section I: Using the Menus Interface
Rebooting the Switch
This procedure reboots the switch and reloads the AT-S80 management
software from flash memory. You can reboot the device if you believe it is
experiencing a problem. Rebooting the switch does not change any of the
its parameter settings.
Caution
The switch does not forward network traffic during the reboot
process. Some network traffic may be lost.
To reboot the switch, perform the following procedure:
1. From the Main Menu type T to select Switch Tools.
The Switch Tools Configuration Menu is shown in Figure 9.
Figure 9. Switch Tools Configuration Menu
2. From the Switch Tools Configuration Menu, type R to select System
Reboot.
Main Menu -> Switch Tools Configuration Menu
Software [U]pgrade...
System [R]eboot
[P]ing Execution
[Q]uit to previous menu
Command>