Allied Telesis AT-S80 - Manual (Page 197)

AT-S80 Management Software User’s Guide
Section I: Using the Menus Interface 197
Configuring MAC Based Access Control Feature
To configure the MAC Based Access Control feature, perform the
following procedure.
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 14 on
page 64.
2. From the Advanced Switch Configuration Menu, type X to select
802.1x Port Based Access Control Configuration.
The Port Based Access Control Configuration Menu is shown in Figure
47 on page 193.
3. From the 802.1x Port Based Access Control Configuration Menu,
type M to select Auth Mode.
The following prompt is displayed:
Select Port based or Mac based auth mode (P/M) >
4. Type M to select MAC Based Access Control.