Allied Telesis AT-S25 - Manual (Page 109)

AT-S25 Management Software User’s Guide
109
Configuring RSTP
This section contains the following procedures:
❑ Configuring a Bridge’s RSTP Settings on page 109
❑ Configuring a Port’s RSTP Settings on page 110
Configuring a
Bridge’s RSTP
Settings
This section contains the procedure for configuring a bridge’s RSTP
settings.
Caution
The default RSTP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how RSTP works might have a negative effect on your network. You
should consult the IEEE 802.1w standard before changing any of the
RSTP parameters.
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu in Figure 31 on page 99 is displayed.
2. From the Spanning Tree Menu, type 2 to select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
3. Type R to select RSTP.
4. Type 4 to select RSTP Configuration.
The RSTP Menu window in Figure 35 is displayed.
Figure 36 RSTP Menu