Allied Telesis AT-S25 - Manual (Page 233)

AT-S25 Management Software User’s Guide
233
Configuring STP
Configuring a
Bridge’s STP
Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The bridge provides default STP parameters that are adequate for
most networks. Changing them without prior experience and an
understanding of how STP works might have a negative effect on
your network. You should consult the IEEE 802.1d standard before
changing any of the STP parameters.
Considering that you have enabled STP as instructed in Enabling or
Disabling STP or RSTP on page 229.
To configure STP, perform the following procedure:
1. From the Spanning Tree window, as displayed in Figure 86 on page
229, with STP Configuration as your selection.
2. Click Configure.