Allied Telesis AT-S25 - Manual (Page 229)

AT-S25 Management Software User’s Guide
229
Enabling or Disabling STP or RSTP
To enable or disable spanning tree protocol (STP) or rapid spanning tree
protocol (RSTP) on the bridge, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 2 tab.
3. From the Layer 2 page, select the Spanning Tree tab.
The Spanning Tree window in Figure 86 is displayed.
Figure 86 Configuration - Spanning Tree Window
4. To enable or disable spanning tree, click the Enable Spanning Tree
check box. A check indicates that the feature is enabled while no
check indicates that the feature is disabled. The default is disabled.
5. If you are activating spanning tree, select either the STP or RSTP in the
Active Protocol Version section of the window. The default is RSTP.
Note
Only one spanning tree protocol can be active on the switch at a
time.
6. Click Apply.
7. If you activated STP, go to Configuring STP on page 233.
8. If you activated RSTP, go to Configuring RSTP on page 238.