Allied Telesis AT-S25 - Manual (Page 83)

AT-S25 Management Software User’s Guide
83
Modifying a Trunk Name
To modify a name of a created trunk port, perform the following
procedure:
1. From the Main Menu, type 1 to select Ports Menu.
2. From the Ports Menu, type 3 to select Port Trunking.
The Port Trunking menu in Figure 25 on page 79 is displayed.
3. From the Port Trunking menu, type M if you wish to select a module
other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
4. Enter the ID of the module you wish to select, and press the Enter key.
5. From the Port Trunking menu, type 4 to select Modify Trunk Name.
The following prompt is displayed.
Enter Trunk Number -> [1 to 6] ->
6. Enter the number of the port trunk you wish to modify the name; then
press the Enter key.
Enter Trunk Name ->
7. Enter the new name you wish to use for the selected port trunk.
8. Press any key to continue.