Viewing static mac addresses only – Allied Telesis AT-S25 User Manual
Page 151
AT-S25 Management Software User’s Guide
151
Figure 53 Show all MAC addresses Window
The information displayed in this window is for viewing purposes
only. The columns are described in the table below:
Viewing static
MAC addresses
only
To display only static MAC addresses, perform the following procedure:
1. From the Main Menu, type 6 to select MAC Menu.
2. From the MAC Menu, type 2 to select Show all static MAC addresses.
A window is displayed with all the MAC addresses. An example of
the Show all MAC addresses window is displayed, as shown in
Figure 54.
PARAMETER
DESCRIPTION
MAC Address
The MAC address of the node connected to the switch.
Module
The module where the MAC address came from.
Port
The port on the switch where the MAC address was
learned.
VlanID
The VID of the VLAN to which the port is an untagged
member.
Type
The MAC address type. The type can be either static or
dynamic or multicast.