Allied Telesis AT-S25 - Manual (Page 99)

AT-S25 Management Software User’s Guide
99
Enabling or Disabling STP or RSTP
To enable or disable a spanning tree protocol (STP) or a rapid spanning
tree protocol (RSTP), perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu in Figure 31 is displayed.
Figure 31 Spanning Tree Menu
2. To select the spanning tree protocol version, type 2 to select STP or
RSTP as Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
3. Type S to select STP or type R to select RSTP.
4. To enable or disable the selected protocol version, type 1 to select
Spanning Tree Status.
The following prompt is displayed.
Enter new value (E-Enable, D-Disable):
5. Type E to enable the RSTP or D to disable it. The default is disabled.
6. If you enable the STP, go to Configuring STP on page 103.
7. If you enable the RSTP, go to Configuring RSTP on page 109.