AT&T Door Phone Controller - Manual (Page 43)

Option Selection
The final step of the installation procedure is selecting options
for your AT&T Door Phone Controller. The selection of these
Refer to Appendix B for a
detailed explanation of each of
options must be done while in the Option Selection Mode. This
these options.
mode lets you control such things as:
■
■
■
■
■
■
■
■
■
Delay Before Door Ajar Call-Back
Ring/Chime Cadence
Ring/Chime Duration
Door Unlock Code
Door Unlock Duration
Enable Door Code
Door Ajar Mode
Forced Disconnect Time-Out
Reset Options to Factory Defaults
Any or all options may be
reselected in any order.
Follow the steps below to select options for the Door Phone
Controller.
1. Select Option Selection Mode by setting position 8
of the Door Phone Controller DIP switch to the ON
position (see Figure 1-1).
2. Once the DIP switch has been set, you must make con-
nection to the door speaker by “hook-flashing” the
phone (within 5 seconds) and entering “##3” on the
telephone keypad (option selection mode is active as
soon as you hear a distinctive dial tone).
3. Use Table 3-1 to make each option selection.
Installation — Home/Residential 3-5