AT&T Door Phone Controller - Manual (Page 96)

AT&T
Door Phone Controller — Option Selection
To Select Options: (1) Set DIP switch location 8 to the ON position. (2) Dial door speaker phone number or
extension. (3) Dial ##3. (4) Program any or all of the following functions, in any order:
Mode Option/ Listen Listen
Options
Verify
Press Press
For For
Default
Delay Before To Select Option 00 Single 000 to 255 for 0 to 255 Double 30 sec.
Door Ajar Beep seconds of delay after strike Beep
Call-back
To Verify 01 plate release stops until
Door Phone Controller calls
back to indicate that door is
ajar
Ring/Chime To Select Option 10 Single 24 (for 2 sec. on 4 sec. off Double 2 sec./
Cadence Beep cadence) or Beep 4 sec.
To Verify 11 15 (for 1 sec. on 5 sec. off
cadence)
Ring/Chime To Select Option 20 Single 00 to 99 (0 to 99 second(s) Double 30 sec.
Duration Beep ring/chime) Beep
To Verify 21
Door Unlock To Select Option 30 Single 4 digits (first digit must be Double 6736
Code Beep 0,3,4,5,6,7 or 8; Beep “OPEN”
To Verify 31 remaining digits can be set
from 0 to 9)
Door Unlock To Select Option 40 Single 00 to 99 (door lock active Double 4 sec.
Duration Beep time in sec.) Beep
To Verify 41
Enable Door To Select Option 50 Single 1 Enable door code Double 1
Code Beep 0 Disable door code Beep (Enabled)
To Verify 51
Door Ajar To Select Option 50 Single 2 For callback after strike Double 2
Mode Beep plate release only Beep
To Verify 51 3 For callback anytime
door is opened
Forced To Select Option 60 Single 010 to 255 (unit disconnects Double 120 sec.
Disconnect Beep in 10 to 255 sec.) Beep
Time-Out To Verify 61
Reset Options To Select Option 70 Single ## (to restore factory default Double N/A
to Factory Beep conditions) Beep
Defaults
To Verify 71
Phone To Select Option 80 Single 0 to 20 numerical digits and Double #
Number Beep ❊ ( ❊ = 2 second pause) # Beep
Storage
To Verify 81 terminates entry
Memory 1
Phone To Select Option 90 Single 0 to 20 numerical digits and Double #
Number Beep ❊ ( ❊ = 2 second pause) # Beep
Storage
To Verify 91 terminates entry
Memory 2
After Selecting Options: (1) Press ##3. (2) Hang up after hearing a double beep confirmation. (3) Set DIP
location 8 back to the OFF position, to prevent unauthorized re-programming. (See other side for DIP Switch Settings.)