AT&T Door Phone Controller - Manual (Page 44)

Table 3-1. AT&T Door Phone Controller Option Selection Information
Mode Option/ Listen Listen
Options
Verify
Press Press
For
Default
Delay Before To Select Option 00 Single 000 to 255 for 0 to 255 Double 30 sec.
Door Ajar Beep seconds of delay after strike Beep
Call-back
To Verify 01 plate release stops until
AT&T Door Phone Controller
calls back to indicate that
door is ajar
Ring/Chime To Select Option 10 Single 24 (for 2 sec. on 4 sec. off Double 2 sec./
Cadence Beep cadence) o r Beep 4 sec.
To Verify 11 15 (for 1 sec. on 5 sec. off
cadence)
Ring/Chime To Select Option 20 Single 00 to 99 (0 to 99 second(s) Double 30 sec.
Duration Beep ring/chime) Beep
To Verify 21
Door Unlock To Select Option 30 Single 4 digits (first digit must be Double 6736
Code Beep 0,3,4,5,6,7 or 8 Beep “ O P E N ”
To Verify 31 remaining digits can be set
from 0 to 9)
Door Unlock To Select Option 40 Single 00 to 99 (door lock active Double 4 sec.
Duration Beep time in sec.) Beep
To Verify 41
Enable Door To Select Option 50 Single 1 Enable door code Double 1
Code Beep 0 Disable door code Beep (Enabled)
To Verify 51
Door Ajar To Select Option 50 Single 2 For callback after strike Double 2
Mode Beep plate release only Beep
To Verify 51 3 For callback anytime
door is opened
Forced To Select Option 60 Single 010 to 255 (unit disconnects Double 120 sec.
Disconnect Beep in 10 to 255 sec.) Beep
Time-Out
To Verify 61
Reset Options To Select Option 70 Single ## (to restore factory default Double N / A
to Factory Beep conditions) Beep
Defaults To Verify 71
NOTE: The Door Ajar Delay (Option Selection) will begin when the call to the door speaker is disconnected.
.
3-6 Installation — Home/Residential