AT&T Door Phone Controller - Manual (Page 63)

Table 5-1. AT&T Door Phone Controller Option Selection Information
Mode Option/ Listen
Options
Listen
Verify Press For
Press
For
Default
Delay Before Door To Select Option 00 Single 000 to 255 for 0 to 255 seconds Double 30 sec.
Ajar Call-back
Beep of delay after strike plate Beep
To Verify 01 release stops until AT&T Door
Phone Controller calls back to
indicate that door is ajar
Ring/Chime To Select Option 10 Single 24 (for 2 sec. on 4 sec. off Double 2 sec./
Cadence
Beep cadence) o r Beep 4 sec.
To Verify 11 15 (for 1 sec. on 5 sec. off
cadence)
Ring/Chime To Select Option 20 Single 00 to 99 (0 to 99 second(s) Double 30 sec.
Duration
Beep ring/chime) Beep
To Verify 21
Door Unlock Code To Select Option 30 Single 4 digits (first digit must be Double 6736
Beep 0,3,4,5,6,7 or 8; Beep “OPEN”
To Verify 31 remaining digits can be set from
0 to 9)
Door Unlock To Select Option 40 Single 00 to 99 (door lock active time Double 4 sec.
Duration
Beep in sec.) Beep
To Verify 4 1
Enable Door Code To Select Option 50 Single 1 Enable door code Double 1
Beep 0 Disable door code
To Verify
Beep (Enabled)
51
Door Ajar Mode To Select Option 50 Single 2 For callback after strike Double 2
Beep plate release only Beep
To Verify 51 3 For callback anytime
door is opened
Forced Disconnect To Select Option 60 Single 10 to 255 (unit disconnects in Double 120 sec.
Time-Out
Beep 10 to 255 sec.) Beep
To Verify 6 1
Reset Options to To Select Option 7 0 Single ## (to restore factory default Double N/A
Factory Defaults
Beep conditions) Beep
To Verify 71
Phone Number To Select Option 80 Single 0 to 20 numerical digits and Double #
Storage Memory 1
Beep
❊ ( ❊ = 2 second pause) # Beep
To Verify 81 terminates entry
Phone Number To Select Option 90 Single 0 to 20 numerical digits and Double #
Storage Memory 2
Beep
❊ ( ❊ = 2 second pause) # Beep
To Verify 91 terminates entry
Installation - Dedicated Station Port 5-7