Sony CDX-G1000U - Manual (Page 14)

14
GB
Quick-BrowZer is a trademark of Sony
Corporation.
Windows Media is either a registered trademark
or trademark of Microsoft Corporation in the
United States and/or other countries.
This product is protected by certain intellectual
property rights of Microsoft Corporation. Use or
distribution of such technology outside of this
product is prohibited without a license from
Microsoft or an authorized Microsoft subsidiary.
MPEG Layer-3 audio coding technology and
patents licensed from Fraunhofer IIS and
Thomson.
Android is a trademark of Google Inc. Use of this
trademark is subject to Google Permissions.
Troubleshooting
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below,
check the connection and operating
procedures.
For details on using the fuse and removing
the unit from the dashboard, refer to the
installation/connections manual supplied
with this unit.
If the problem is not solved, visit the support
site on the back cover.
General
No sound.
 The position of the fader control [FADER] is
not set for a 2-speaker system.
No beep sound.
 An optional power amplifier is connected and
you are not using the built-in amplifier.
The contents of the memory have been
erased.
 The power supply lead or battery has been
disconnected or not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes a noise when the position of the
ignition is switched.
 The leads are not matched correctly with the
car’s accessory power connector.
During playback or reception, the
demonstration mode starts.
 If no operation is performed for 5 minutes
with [DEMO-ON] set, the demonstration
mode starts.
 Set [DEMO-OFF] (page 11).
The display disappears from/does not appear
in the display window.
 The dimmer is set to [DIM-ON] (page 11).
 The display disappears if you press and hold
OFF.
 Press OFF on the unit until the display
appears.
 The connectors are dirty (page 13).
The operation buttons do not function.
The disc will not eject.
 Press DSPL and
(back)/MODE for more
than 2 seconds to reset the unit.
The contents stored in memory are erased.
For your safety, do not reset the unit while
you are driving.
Radio reception
Stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
 Check the connection of the car antenna
(aerial).
 If the auto antenna (aerial) will not extend,
check the connection of the power
antenna (aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
Copyrights