Alto-Shaam MN-28656 - Manual (Page 9)

S TA RT- U P
7.
L O W T E M P E R AT U R E C O O K I N G I N T R O D U C T I O N
O V E N C H A R A C T E R I S T I C S
The cabinet is equipped with a special, low-heat-
density, heating cable. Through the Halo Heat
®
concept, the heating cable is mounted against the
walls of the cooking and holding compartment to
provide an evenly applied heat source, controlled
by an oven sensor. The design and operational
characteristics of the unit eliminate the need for a
moisture pan or a heat circulating fan. Through even
heat application, the food product is cooked
uniformly and provides the ability to hold foods for
longer periods of time.
H E AT R E C O V E RY
The patented SureTemp
™
heat recovery system in
this oven reacts immediately to compensate for any
loss of heat whenever the door is opened. If the
door remains open for more than three minutes, the
solid state electronic control will sound three rapid
beeps every ten seconds until the door is closed.
1. Before operating the oven,
clean both the
interior and exterior of the oven with a damp
cloth and any good commercial detergent at
the recommended strength. Rinse surfaces by
wiping with a sponge and clean warm water to
remove all detergent residue. Wipe dry with a
clean cloth or air dry.
2. Wipe door gaskets
and control panel dry with
a soft cloth.
3. Clean and install
the oven side racks, oven
shelves, and external drip tray. Shelves are
installed with curved edge up and toward the
back of the oven. Insert the drip pan on the
interior bottom surface of the oven.
4. Before operating
the oven with product, become
familiar with the operation of the controls.
Read the following “Control Identification and
Function
” and the “Control Operation”
sections of this cooking guide and begin by
operating the various control functions.
D A N G E R
AT NO TIME SHOULD THE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION OF
ANY KIND. DO NOT USE WATER JET
TO CLEAN.
SEVERE DAMAGE OR
ELECTRICAL HAZARD
COULD RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED