Sony CCD-TRV101E - Manual (Page 96)

96
CCD-TRV101E.3-856-814-11 (E,S)
Cause and/or corrective actions
• Moisture condensation has occurred.
m Remove the cassette and leave the camcorder for at
least 1 hour. (p. 90)
• Reset the date and time. (p. 82)
• The cassette was ejected after you recorded on it.
m The End Search function will not activate until you
make a new recording after reinserting the cassette.
• The POWER switch is set to CAMERA or OFF.
m Set it to PLAYER. (p. 23)
• The tape has run out.
m Rewind the tape or use a new one. (p. 23)
• STEADYSHOT is set to OFF in the menu system.
m Set it to ON. (p. 52)
• The SteadyShot function does not work when the wide
mode is set to 16:9FULL.
• The stereo tape is played back with HiFi SOUND set to 1
or 2 in the menu system.
m
Set it to STEREO. (p. 32)
• The picture has been recorded with WIND set to ON in
the menu system.
m
When there is no wind, set it to OFF. (p. 32)
• The START/STOP MODE switch is set to 5SEC or .
m Set it to . (p. 15)
• Focus is set to the manual mode.
m Set it to autofocus. (p. 57)
• Shooting conditions are not suitable for autofocus.
m Set focus to manual mode to focus manually. (p. 57)
• There are unwanted blanks before or after the title.
m Delete them, then select
↵
. (p. 50)
• The START/STOP MODE switch is set to 5SEC or .
m Set it to . (p. 15)
• A title is displayed.
m Turn off the title. (p. 48)
Operation
Symptom
{ and 6 indicators flash and no function
except for cassette ejection works.
The date or time indicator displays bars
(--:--:--).
The End Search function does not
activate.
The tape does not move when a tape
transport button is pressed.
The SteadyShot function does not activate.
No sound or only a low sound is heard
when playing back a tape.
Excessive high-piched sound is heard.
Recording stops in a few seconds.
The autofocus function does not activate.
The title display position shifts.
The fader function does not work.
Trouble check