Acer Altos G900 - Manual (Page 116)

3 Hardware configuration 100
Hot-swap drive bays
The hot swap drive bay assemblies come with a backplane board and a
fan. Each drive slot contains a drive carrier with a plastic air baffle.
Removing and installing a hot-swap drive bay
To remove a hot-swap drive bay
1 Turn off power to the server and unplug the AC power cords from
the power source.
2 Open and remove the front subchassis (refer to page 47 and 48).
3 Remove the fan modules and the foam fan baffle (refer to
page 88).
4 Remove the four screws (two on each side) that secure the drive
bay assembly to the front subchassis.
Figure 53 - Removing a hot-swap drive bay
AA G900 ug - EN.book Page 100 Wednesday, September 25, 2002 5:23 PM