Acer Altos G900 - Manual (Page 62)

3 Hardware configuration 46
To remove the front access panel
1 Remove the rear access panel (refer to page 44).
2 Release the two captive panel screws (Figure 13, A).
3 Lift the rear edge of the panel slightly and slide it toward the rear
of the chassis.
4 Lift the panel up and off of the chassis.
To install the front access panel
Note: Before installing the front access panel, check that you
have not left tools or loose parts inside the system.
1 Position the panel on the chassis so that the panel tabs align with
the chassis slots.
2 While lightly pressing the panel against the chassis, slide it toward
the front of the chassis until the panel tabs fully engage the chassis
slots.
3 Attach the panel to the chassis with the captive screws.
4 Reinstall the rear access panel (refer to page 45).
Figure 13 - Removing the front access panel
AA G900 ug - EN.book Page 46 Wednesday, September 25, 2002 5:23 PM