Acer Altos G900 - Manual (Page 170)

Appendix A: System rack installation 154
3 Remove the screw (Figure 63, B) that holds the rear foot to the
chassis, slide the foot upward, then remove the foot.
Note: If the rack system will ever be converted back to a tower
configuration, be sure to keep all unused tower parts—the tower
bezel, keys, bottom and left panels, feet, and two screws—for
future use.
Installing the rack bezel
1 Remove the rack bezel keys that are taped to the inside of the rack
bezel and secure them for future use. At a minimum, attach them
to the plastic key clip located on the rear panel of the system so
they do not get lost.
2 Open the door on the rack bezel from the rack conversion kit.
3 Align the eight tabs on the rack bezel with the eight slots on the
front of the chassis.
Figure 63 - Removing the feet
AA G900 ug - EN.book Page 154 Wednesday, September 25, 2002 5:23 PM