Acer Altos G900 - Manual (Page 70)

3 Hardware configuration 54
Processor board air baffle
To remove the processor board air baffle
1 At the end of the air baffle closest to the rear of the chassis, press
the two tabs toward each other (Figure 20, A) and raise the end,
rotating the baffle about 30°.
2 Disengage the air baffle at the front of the electronics bay and
remove the baffle from the chassis.
To install the processor board air baffle
1 Orient the baffle so that the two release tabs are toward the rear
of the chassis.
2 With the rear of the air baffle raised, insert the tab on the front of
the air baffle into the slot in the chassis.
Holding the baffle at an angle of about 30° will allow the tab to
engage correctly.
3 Rotate the rear end of the baffle down. Adjust the position of the
baffle until it moves into place and the two tabs are engaged. Do
not force it down.
Figure 20 - Removing the processor board air baffle
AA G900 ug - EN.book Page 54 Wednesday, September 25, 2002 5:23 PM